...
Make sure that the Lightspeed Amp is turned on.
If the device is on the power light will glow white.
If the device is off, push the Power button to turn it on.
If you need to adjust the volume of the room (after checking the volume settings on your presentation computer and all other devices) select the Audio Input button and turn the Power button to turn the volume up or down.
Select either the handheld (tall) microphone or the presenter mic/lanyard mic (short) microphone from the charging cradle on top of the corner podium desk.
To turn the handheld microphone on, push the Power button in the middle and the indicator light will switch from white to blue.
To adjust the volume of the handheld (rarely if ever necessary) microphone select the Up and Down arrow buttons under the Power button.
To turn the lavalier microphone on, push the Power button on the top and the indicator light will switch from white to blue.
To adjust the volume of the handheld microphone (rarely if ever necessary) select the Up and Down arrow buttons on the side of the microphone.
When you are finished with your presentation please turn off the microphone and return it to the charging station located on top of the corner podium desk.
Pyle VocoPro Board Meeting Microphone System
Sytem
POWER ON the Black Pyle ALL four VocoPro Microphone head end box. Ensure the Black Pyle Microphone head end system is powered on. It’s boxes. They’re located under the corner podium desk. The power button is on the front.
...
Once on, a red light will glow above each power button.
...
Turn on each podium mic: Hold the Power button on the Pyle VocoPro microphone for 3 seconds to turn it on.
Do not select the Up and Down buttons, this will adjust the RF which has already been set.
Adjust microphone volume using the knob on the back. (Please leave it alone unless there's a significant issue. They should already be adjusted)
...
After you do this a yellow light will turn on above the corresponding letter assigned to the microphone on the VocoPro Microphone head end box.
To mute your microphone TAP the Power button and the green
...
light on the
...
base will
...
turn red. To unmute, select the Power button again and the
...
base light will
...
turn green again.
When done with the system TURN ALL MICROPHONES OFF by holding down the power button for three seconds. The
...
base lights will go blank when the microphones are turned off. Failing to turn the microphones off will result in dead batteries.
Optional but encouraged:
...
When done with the system turn off the
...
VocoPro head end
...
boxes located under the corner podium.
